forked from daid/LegacyCura
-
Notifications
You must be signed in to change notification settings - Fork 0
/
changelog
56 lines (49 loc) · 2.9 KB
/
changelog
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
Development
* Added an expert parameter for the wipe tower size, and made brim go around the wipe tower
* Added experimental support for printing with the Doodle3D WiFi box
* Updated object boundaries for multi-object prints, allows for tighter fitting of objects on the build platform
* Updated time-estimate to greatly improve accuracy of the estimate.
* Fixed problem with retractions not happening when they should.
* Added keyboard control for the 3D window to look around with cursor keys.
Ultimaker2 - Firmware update - 13.12
* Fixed the problem where aborting a print did not always home the head.
* Fixed bug in acceleration planning causing slow moves on rare occasions.
* Disable the normal menus during USB printing, and support for USB based menus.
* Disable stepper drivers after print is finished or aborted, so you can manually move the head.
* Expert feature: Support M907 for setting the motor current.
Ultimaker Original - Firmware update - 13.12
* Fixed bug in acceleration planning causing slow moves on rare occasions.
* Updated to new ErikZalm Marlin base, fixing the long standing slower retraction bug.
13.11.2
* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
* Added disallowed zones for UM2
* Added ooze-shield for dual-color printing
* Added wipe tower for dual-extrusion
* Added no-go zones for UM2 glass clips
Ultimaker2 - Firmware update - 13.11-2
* Fixed UM2 build volume offset so that you do not print off the glass plate.
* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
* Slightly tweaked the SD-Card error problems.
* Added LED settings to Tune menu
* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
13.11
* Added imageToMesh tool to load images as 3D height maps
* Fixed Z support distance when using "everywhere" support.
* Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
* Fixed "Reset profile" so it no longer resets the machine settings.
* Updated support material so support is smoother and has less small sections which are hard to remove.
* Fixed start-gcode when using dual-support material
* Change how the fan is handled on lower layer to improve UM2 printing.
* Fix that retraction is enabled when selecting UM2 or RepRap.
* Scale down very large models, or scale up very tiny models automagicly.
* Fixed skirt and brim to go around the support instead of under it.
* Added spiralize mode
Ultimaker2 - Firmware update - 13.10-5
* Fixed SD-Card read error
* Added feature to store your own material presets
* Fixed the 280C ABS problem, causing a temperature sensor error
13.10
* Added YouMagine upload button
* Added multiple machine support
* Redone support material