| title | description | addedAt | pageClass |
|---|---|---|---|
Enbrighten 43100 control via MQTT |
Integrate your Enbrighten 43100 via Zigbee2MQTT with whatever smart home infrastructure you are using without the vendor's bridge or gateway. |
2020-09-01 19:56:51 UTC |
device-page |
| Model | 43100 |
| Vendor | Enbrighten |
| Description | Plug-in Zigbee outdoor smart switch |
| Exposes | switch (state), linkquality |
| Picture |  |
- Unplug the smart switch from the outlet
- Hold down the push button.
- Plug the smart switch back into the outlet while holding down the push button.
- Release button after the smart switch is plugged in. You must release button within four seconds of plugging in the switch.
The current state of this switch is in the published state under the state property (value is ON or OFF).
To control this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state": "ON"}, {"state": "OFF"} or {"state": "TOGGLE"}.
To read the current state of this switch publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"state": ""}.
Link quality (signal strength).
Value can be found in the published state on the linkquality property.
It's not possible to read (/get) or write (/set) this value.
The minimal value is 0 and the maximum value is 255.
The unit of this value is lqi.