Description
After installing 2.3.6 (IDE) started having issues with the GIGA and loosing the com port while working on Display.
After several tries of rebuilding in ubuntu opted to reinstall 0.3.1 core via the board manager after removing the old core. I did incorporate the USB fixes to make sure I had that covered.
After that I closed the IDE and reopened it. Burned the bootloader and ran the ASCIItable example sketch. Again no com port showed after uploading sketch.
If I cycle power (unplug and replug it back it in) I get the Com port back and serial monitor prints out the table. But if I hit restart I loose the com port again and nothich shows on serial1 for errors.
If I try loading the sketch in debug mode the sketch loads and runs correctly without loosing the com port.
reloading in standard mode it goes back to no comport until I cycle power.
No clue whats going on......
Dont believe @KurtE is having any issues with the giga.
Note. Tried teh C33 and not seeing this problem. Havent tried the H7 yet.
UPDATE: Tried the H7 and not seeing the problems that I am having on the giga.