Autobaud should try 921600bps

[marcus-aa]

Early Mode-S-Beasts seem to use 921600bps, would be good to try this when using autobaud.

Mar 03 15:09:53 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): opening port at 1000000bps
Mar 03 15:09:53 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): configured with settings: BCdfgHijk
Mar 03 15:09:55 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): autobaud failed, trying again (consider specifying --fixed-baud)
Mar 03 15:09:55 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): opening port at 3000000bps
Mar 03 15:09:55 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): configured with settings: BCdfgHijk
Mar 03 15:09:59 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): opening port at 1000000bps
Mar 03 15:09:59 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): configured with settings: BCdfgHijk
Mar 03 15:10:03 P-ESGT4 beast-splitter[9374]: serial(/dev/ttyUSB1): autobaud failed, trying again (consider specifying --fixed-baud)


Mar 03 15:11:04 P-ESGT4 beast-splitter[10050]: serial(/dev/ttyUSB1): opening port at 921600bps
Mar 03 15:11:04 P-ESGT4 beast-splitter[10050]: serial(/dev/ttyUSB1): configured with settings: BCDfgHIjk
Mar 03 15:11:04 P-ESGT4 beast-splitter[10050]: localhost:30004: connected to 127.0.0.1:30004 with settings BCdfgi

[marcus-aa]

Found this. 921600 is used when the Rx has also an ETH or BT interface.

It has also slower settings but I have never seen them in use.

https://wiki.jetvision.de/wiki/Mode-S_Beast:DIP_Switches