Please anyone help me ?

[myfavorchat001-lang]

Can anyone help me:

I have and 8 8 Channel PWM PPM SBUS Signal Converter:

I want to connect to my F7 V3 FC i used an INav configurator, please any one help how i can connect:

SBUS to ?
GND - GND
VCC - VCC 5V

To my F7 V3 FC?

I have spare UART RX - TX where i connect my SBUS to but in RX or TX i dont know???

I want to use SBUS serial
I have already ExplessLRS receiver in UART 2 Port

I am novice

[sensei-hacker]

What is the purpose of connecting a PWM-to-sbus converter? What is the end goal you are actually trying to achieve?

[myfavorchat001-lang]

I want to used an 8 Channel pwm sbus stream converter to get more Servo output in my drone, currently my FC have only 2 Spare servo output?

I want 5 to servo output?

Please guided me?

[sensei-hacker]

Ah yes, you mentioned "F7V3“ - I guess you got the Speedybee with four "unusable" outputs?
It looks like it has nine channels, but they screwed up the sequence.

You COULD have five distinct servo channels and four motors by putting the motors on S1, S2, S4, and S5. That means soldering rather than using the plug.

You can also use the sbus adapter by setting servo_protocol to SBUS or SBUS_PWM

Connect the adapter to the tx pin of the uart.