toy-robot-php-cli

The application is a simulation of a toy robot moving on a square tabletop, of dimensions 5 units x 5 units.
There are no other obstructions on the table surface.
The robot is free to roam around the surface of the table, but must be prevented from falling to destruction. Any movement that would result in the robot falling from the table must be prevented, however further valid movement commands must still be allowed.
This project has been developed using Laravel Zero Framework v8.0 using PHP v7.3

This application reads commands of the following form:

PLACE X,Y,F
MOVE
LEFT
RIGHT
REPORT

PLACE will put the toy robot on the table in position X,Y and facing NORTH, SOUTH, EAST or WEST.
The origin (0,0) is SOUTH WEST most corner of the tabletop.
The first valid command to the robot is a PLACE command, after that, any sequence of commands may be issued, in any order, including another PLACE command. The application will discard all commands in the sequence until a valid PLACE command has been executed.
MOVE will move the toy robot one unit forward in the direction it is currently facing.
LEFT and RIGHT will rotate the robot 90 degrees in the specified direction without changing the position of the robot.
REPORT will announce the X,Y and F of the robot.
A robot that is not on the table will ignore the MOVE, LEFT, RIGHT and REPORT commands.
Input can only be from a file.
Tests included in the project.

Constraints

The toy robot must not fall off the table during movement. This also includes the initial placement of the toy robot.
Any move that would cause the robot to fall must be ignored.

PLACE 1,2,EAST
MOVE
MOVE
LEFT
MOVE
REPORT

Expected output:

3,3,NORTH

The code assumes you have Docker running on your machine. If you do not, they offer easy to install binaries (Mac) (Windows).

Clone this repository
From the root of this project, run docker-compose up -d --build which will start the php-cli container that will be used to run this application on.
After the php-cli container is up, run sudo chmod +x ./toy-simulator.sh which will make ./toy-simulator.sh script executable
Now run ./toy-simulator.sh simulate-robot to run the application using the default input.txt file placed at the path app/Data/input.txt
To run the application using a different input file on the path app/Data/input2.txt, run ./toy-simulator.sh simulate-robot Data/input2.txt
To run the tests, run ./toy-simulator.sh test
Make sure to stop the docker container after you are done using the application. For stopping the container run docker-compose down

NOTE: Please don't change or remove the files with prefix test-input, inside the path app/Data path, since those files are used by the tests.