| layout | title |
|---|---|
documentation |
DSC27 - ZWave |
{% include base.html %}
This describes the Z-Wave device DSC27, manufactured by AEON Labs with the thing type UID of aeon_dsc27_00_000.
The DSC27 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
No device information is provided in the database. Consider updating the database to improve the documentation.
The following table summarises the channels available for the DSC27 -:
| Channel | Channel Id | Category | Item Type |
|---|---|---|---|
| Dimmer | switch_dimmer | DimmableLight | Dimmer |
The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.
The switch_dimmer channel supports the Dimmer item and is in the DimmableLight category.
The following table provides a summary of the 2 configuration parameters available in the DSC27. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 80 | Notification on Status Change | Parameter to Enable to send notification to associated devices (Group 1) when the state of Micro Dimmer's load changed |
| 120 | Turn External Button Mode | Parameter to set External button type |
| Switch All Mode | Set the mode for the switch when receiving SWITCH ALL commands |
Parameter to Enable to send notification to associated devices (Group 1) when the state of Micro Dimmer's load changed
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Deactivate |
| 1 | Hail CC Sent |
| 2 | Basic CC Report Sent |
The manufacturer defined default value is 0 (Deactivate).
This parameter has the configuration ID config_80_1 and is of type INTEGER.
Parameter to set External button type
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Momentary Button Mode |
| 1 | 2 State Switch Mode |
| 2 | 3 Way Switch Mode |
The manufacturer defined default value is 255.
This parameter has the configuration ID config_120_1 and is of type INTEGER.
Set the mode for the switch when receiving SWITCH ALL commands.
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Exclude from All On and All Off groups |
| 1 | Include in All On group |
| 2 | Include in All Off group |
| 255 | Include in All On and All Off groups |
This parameter has the configuration ID switchall_mode and is of type INTEGER.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The DSC27 supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_MULTILEVEL_V2 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_SCENE_ACTIVATION_V1 | |
| COMMAND_CLASS_SCENE_ACTUATOR_CONF_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.