| layout | title |
|---|---|
documentation |
507900 - ZWave |
{% include base.html %}
This describes the Z-Wave device 507900, manufactured by Merten with the thing type UID of merten_507900_00_000.
The 507900 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
The flush-mounted CONNECT radio receiver, 1-gang universal dimmer, will be referred to below as "dimmer".
The dimmer is used to switch and dim luminaires (see technical data) via radio signal and via an extension push-button connected directly to the dimmer.
The dimmer automatically recognises the connected load, is overload-proof, short-circuit-proof and hum-free, and has a soft start function which slowly dims up a connected load.
Teaching (transmits Node info frame), see CONNECT radio system description
Reset to the factory settings; de- lete everything taught
The following table summarises the channels available for the 507900 -:
| Channel | Channel Id | Category | Item Type |
|---|---|---|---|
| Dimmer | switch_dimmer | DimmableLight | Dimmer |
The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.
The switch_dimmer channel supports the Dimmer item and is in the DimmableLight category.
The following table provides a summary of the 1 configuration parameters available in the 507900. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 196 | Dimmer speed | Set dimming speed. fast=0 ... 240=slow. |
| Switch All Mode | Set the mode for the switch when receiving SWITCH ALL commands |
Set dimming speed. fast=0 ... 240=slow.
Values in the range 0 to 240 may be set.
The manufacturer defined default value is 0.
This parameter has the configuration ID config_196_1 and is of type INTEGER.
Set the mode for the switch when receiving SWITCH ALL commands.
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Exclude from All On and All Off groups |
| 1 | Include in All On group |
| 2 | Include in All Off group |
| 255 | Include in All On and All Off groups |
This parameter has the configuration ID switchall_mode and is of type INTEGER.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The 507900 supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_MULTILEVEL_V1 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_SWITCH_TOGGLE_MULTILEVEL_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_PROTECTION_V2 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 | |
| COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.