about windows

[iwantwin0]

Hello, I encountered a problem while using KataHex. I downloaded the Windows version from your Releases, and I have also set up HexUI. However, when I finish setting the paths and click "OK," an error occurs.

[selinger]

OK, unfortunately I don't know how to fix this. HexGUI sometimes gives strange errors, and I have not used it on Windows. What I would try is: first run HexGUI without attaching KataHex. Run it from a terminal if possible, so that you can see any log information that it writes. Then try to run KataHex without HexGUI, also from a terminal. It should output some messages, pause a few seconds, and then output something like "beginning main protocol loop". At that point you should be able to type commands like "showboard" and "quit". If KataHex fails to run, HexGUI may give errors.

[iwantwin0]

Okay, thank you