Live and go2rtc docs updates

docs/docs/configuration/live.md

@@ -205,7 +205,9 @@ Note that disabling a camera through the config file (`enabled: False`) removes
 
    When you have go2rtc configured, Live view initially attempts to load and play back your stream with a clearer, fluent stream technology (MSE). An initial timeout, a low bandwidth condition that would cause buffering of the stream, or decoding errors in the stream will cause Frigate to switch to the stream defined by the `detect` role, using the jsmpeg format. This is what the UI labels as "low bandwidth mode". On Live dashboards, the mode will automatically reset when smart streaming is configured and activity stops. Continuous streaming mode does not have an automatic reset mechanism, but you can use the _Reset_ option to force a reload of your stream.
 
-   If you are still experiencing Frigate falling back to low bandwidth mode, you may need to adjust your camera's settings per the (recommendations above)[#camera_settings_recommendations].
+   If you are using continuous streaming or you are loading more than a few high resolution streams at once on the dashboard, your browser may struggle to begin playback of your streams before the timeout. Frigate always prioritizes showing a live stream as quickly as possible, even if it is a lower quality jsmpeg stream. You can use the "Reset" link/button to try loading your high resolution stream again.
+
+   If you are still experiencing Frigate falling back to low bandwidth mode, you may need to adjust your camera's settings per the [recommendations above](#camera_settings_recommendations).
 
 3. **It doesn't seem like my cameras are streaming on the Live dashboard. Why?**
 

docs/docs/guides/configuring_go2rtc.md

@@ -115,3 +115,7 @@ section.
 
 1. If the stream you added to go2rtc is also used by Frigate for the `record` or `detect` role, you can migrate your config to pull from the RTSP restream to reduce the number of connections to your camera as shown [here](/configuration/restream#reduce-connections-to-camera).
 2. You may also prefer to [setup WebRTC](/configuration/live#webrtc-extra-configuration) for slightly lower latency than MSE. Note that WebRTC only supports h264 and specific audio formats and may require opening ports on your router.
+
+## Important considerations
+
+If you are configuring go2rtc to publish HomeKit camera streams, on pairing the configuration is written to the `/dev/shm/go2rtc.yaml` file inside the container. These changes must be manually copied across to the `go2rtc` section of your Frigate configuration in order to persist through restarts.