Multiloader firmware for the SAMD_Loader board - user can now select from one of 3 payloads
-
(1) - hekate_ctcaer_3.2
-
(2) - ReiNX Launcher
-
(3) - SXOS Launcher
If you would like to purchase a pre-built board, please see Tindie Page
This firmware was inspired by, and borrows from, mattytrog's implementation of Gemma multiloader. Thanks mattytrog!
On powerup, the board will blink the blue activity LED 1, 2, or 3 times to indicate active payload
To change payload - hold the change button (D1), the device will cycle through 1, 2, then 3 blinks to indicate payload selection. Let go of change button once your desired payload is indicated
To store payload, momentarily press the store button (D0). The activity LED will light for 1 second to indicate flashing and upon the next reset, your desired payload will be automatically selected.
The rest is the same, device will blink 1-3 times while searching for Tegra, then give a short-long "Ta-daa" blink as the payload is sent and activated. At that point, you're done! Unplug and switch the loader off.