Printer model
Core One L
Firmware version
6.8.1+16182
Upgrades and modifications
No response
Printing from...
Connect
Describe the bug
When the filament ran out towards the end of my tall print, it triggered the automatic run-out procedure and I exchanged filament. When the print was resuming after purging, the nozzle went too low in Z and crashed into the part, knocking it over. It then went to the next part and crashed into that too.
This file has printed correctly previously, so it is not a problem with the model or print settings, it looks to be an issue with the auto runout procedure in tall prints, maybe related to limited Z range, the crash was at Z=285mm
How to reproduce
No response
Expected behavior
No response
Files
Printer model
Core One L
Firmware version
6.8.1+16182
Upgrades and modifications
No response
Printing from...
Connect
Describe the bug
When the filament ran out towards the end of my tall print, it triggered the automatic run-out procedure and I exchanged filament. When the print was resuming after purging, the nozzle went too low in Z and crashed into the part, knocking it over. It then went to the next part and crashed into that too.
This file has printed correctly previously, so it is not a problem with the model or print settings, it looks to be an issue with the auto runout procedure in tall prints, maybe related to limited Z range, the crash was at Z=285mm
How to reproduce
No response
Expected behavior
No response
Files